News

Clothes are wet after Spin Cycle

Clothes Pile

The clothes are wet after spinning

 
When the clothes are wet at the end of a cycle, check these:

First: If you using a high-efficiency washer check to be sure you are you using the right type of soap.

Next: Check the owner’s manual.

If you are experiencing a mechanical issue they typically fall into these categories:

Here are tips to evaluate each component:

Motor coupler:

To test the motor coupler, re-start the washer in its spin cycle. Let the machine run for a minute, and then open the lid and notice whether the tub is spinning: If it’s spinning when you lift the lid, the coupler is fine.

If it isn’t spinning, and your machine was produced by Whirlpool®, you may have a broken coupler. At Los Angeles Appliance Repair Service we offer a different kind of service; a service that comes with the guarantee of dependability and value. Los Angeles Washer & Dryer Service uses only genuine brand-name commercial grade components designed specifically for Maytag, Kenmore, and Whirlpool washers and dryers. These original manufacturer’s replacement parts ensure both strength and dependability for years of reliable performance.

Spin Cycle Speed:

 
If the washer doesn’t reach its proper spin speed, the clothes may be too wet at the end of a cycle. Check to be sure the load is properly balanced and run a spin cycle again. If the clothes are still wet, you may have a worn or loose belt (Maytag®), a worn clutch (GE®/Hotpoint®), or a worn motor pulley or tub bearing. This requires replace the applicable component. We can assist you in making an informed decision of your washer, is it worth fixing? or should it be replaced?

Alternatively, there could be clothes caught between the inner and outer tubs.

For additional troubleshooting read the “It spins but won’t pump” section of the “It won’t drain” section. Also, there could be other things that cause friction on the drive train.

Siphoning:

 
If the water that pumps from the machine goes right back into the machine after the spin cycle, it may be because your washer is siphoning the water from a laundry tub with a slow drain, back into the washer.

Leave a Reply

“Our commitment to customer service hasn’t changed in over 50 years: It’s the family tradition!”